It is not the intent of this catalog to show the limitations of the Dri-Design® product line, but rather to show the concept of Exterior Technologies Group, Inc. products that may be custom modified for application to specific products. Exterior Technologies Group, Inc. welcomes the opportunity to assist in the design and application of its products. Details shown are for the purpose of best illustrating the product. In many cases specific construction and sealant details have been omitted from the illustrations. Assembly and installation instructions should be obtained from Exterior Technologies Group, Inc. prior to installation. In order to provide the best possible products, Exterior Technologies Group, Inc. reserves the right to modify components without prior notice. Laws, building codes, and safety codes vary widely concerning the design and use of metal wall panels. Exterior Technologies Group, Inc. does not control the selection and use of its standard products and therefore assumes no responsibility for misapplication.

Dri-Design® Details
Extruded Trims
Sill Detail Typical Horizontal Joint Inside Corner Outside Corner Typical Parapet Coping	Vertical Wall to Soffit Typical Vertical Joint Window/Door/Head/Jamb Window Sill
Formed Flashing Details
Sill Detail Typical Horizontal Joint Inside Corner Outside Corner Typical Parapet Coping	Vertical Wall to Soffit Typical Vertical Joint Window/Door/Head/Jamb Window Sill
Pre-Engineered Metal Building Details
Base Detail Horizontal Joint Window/Head Detail Soffit Detail	Termination Detail Parapet Detail 1 Parapet Detail 2

Dri-Design® details are available on disk. Please call our customer service department and request that a copy be sent to you.